How to solve 3x3 Rubik's Cube? Cubic Tricks

Rubik's Cube is a puzzle cube, and the world's biggest selling toy of all time. If  you are a beginner or intermediate, for all type of new learners there is only 4 steps in solving 3x3 Rubik's Cube.



Before going to start learning the Rubik's cube, it's better to learn the basic parts and moves of it. 

Learn basics here...


Step 1 : Solve the Cross
Location: India

Comments

Post a Comment

Popular posts from this blog

How to Learn a Rubik’s Cube faster?

It is easy to learn Rubik's Cube from basic to advanced level. Based on one's personal interest and hard work, they can learn it even in 1 day. Lots of resources like videos and blogs are available in online to learn the Rubik's Cube. Beyond learning this Rubik's Cube, there are events and competitions also conducted world - wide. Initially you should learn the basic moves and symbols , then you can move to learn the solving steps. You can take a note of each step that you get and practice repeatedly to memorize it. Then you can do it faster.                                         If you want to improve your speed in solving 3x3 cube or any other Rubik's Cube, timers can be used. Each and every time you will try to break the previous timing set, this will make you learn new steps and faster ideas for better results. You can take your own self videos of solving the cu...
Read more

How to make LED and switch circuit using Arudino UNO?

Image
 Are you a beginner for Arduino UNO? Then this is the right place to learn basics of Arduino with all steps and explanations. Required things: Arduino IDE - Can be downloaded in the official website Arduino UNO board - 1 Arduino UNO cable - USB A to B - 1 Jumper wires - 4 Led - red color - Led1 - 1 Resistor - 220 Ω - R1 - 1 Resistor - 10K or 15K Ω - R2 - 1 Pressing switch - S1 - 1 Breadboard - 1 Before running any project using Arduino, first we need to design the circuit, then program it using Ardiuno UNO and upload it, then make the connections as per circuit design with respect to the pins of Arduino UNO broad and finally power up the board with any 5V USB power supply. Thats all, the project will run based on our program. Here we turn on a led using a switch. The logic is simple, when the switch is pressed, led lights up, when released, led goes off. Switch HIGH -  Led HIGH Switch LOW - Led LOW Next you need to set up the hardware connections as mentioned in the above cir...
Read more